Or, do you need to use the 8 channel mode on the parcans? Is there a lower channel count mode that still offers all the features you want but could be better fit between the 48 faders or the 12 fixture controls? Maybe only some of your parcans you need "total control" - use the fixture panel for this, much easier to set up colour and strobes etc. You can of course "double-up" by either setting more than one parcan at the same DMX address or using multiple patching on the Fat Frog. However you will be able to record what I understand you want. It will be a bit clunky to drive though, using a mixture of faders and fixture controls. So that would give you up to 18 of your parcans all with independent control of all 8 DMX channels on the parcan.
Mem patch make sure you can plus#
So if you want individual control of every one of your 8 channel parcans you can get at most 48/8=6 on the faders plus another 12 on the fixtures bank. The 12 fixtures can be much more complicated beasts - one fixture has brightness, colour, beamshape, position etc. In Fat Frog in wide mode you have 48 faders (these are one control channel each) plus you have the 12 fixtures control on the right. This is never going to work how you think - on any lighting desk. You’re not repatching faders you’re moving the DMX address where your fixtures live. I am sure it should do this but I just cannot see what I am doing wrong. I was under the impression once you saved a scene of chase into a mem or submaster then it was stores and could be run from the mem or submaster, but it seems to me that the changing of the addresses of the fadres is killing the memories and sub mastersĬan I only ever use 48 addresses or is there a step I am missing ? getting ready to out this to the skip it is so frustrating but the faders are giving output on 49 to 96. Lights, but now the first chase saved into memory does not run nor does the mem 1.
Mem patch make sure you can manual#
Go to super used, desk setup patching, manual patch and change the DMX addresses on the faders to 49 to 96 to do the same chase on the second bank of So i set the first bank to 1 to 48, program with faders into mem 1 a chase and then transfer without time to a sub master, all works well so far.
I have 4 banks of 4 par cans all having 8 DMX addresses and I want to set them up all on different addresses requiring 32 addresses per bank.
HI I posted about this before but just got pointed to the manual so maybe It is me that is getting this all wrong so forgive the longer description.
0 kommentar(er)
